Psp Battery Pandora Program

Posted By admin On 24/04/18

How to create a Pandora's Battery WITHOUT a PSP Disclaimer:I do not hold any responsibility for any damage done during this. Also, the unbricking of a PSP is not illegal but many use it for illegal purposes. Please do not do so as it hurts the reputation of the community of PSP homebrews. Easoinstaller.exe Fifa 07 there.

Psp Battery Pandora ProgramPsp 3000 Pandora Battery

Create Pandora Battery and Patch. Smoke came out along with sparks i took my battery and turned it into pandora, modded his psp. Residency Program; Gift. PSP Pandora Battery Easy Installer - Downgrade/unbrick any PSP with 3.52 and below.

Things needed: A. 2 PSP Batteries B. Any PSP (1000 or 2000, any firmware version, unbricked or bricked) C.

PSP Pandora Battery Easy Installer - Downgrade/unbrick any PSP with 3.52 and below.

Butter knife or something flat and easy to use. (NOT SHARP) D. Soldering Iron E. At LEAST 256MB Memory Stick F.

The Battery NOTE: delicate process please be careful unlike me 1. Take 1 battery that you want to be the Pandora. Open the casing by using a butterknife or something flat, BUT NOT SHARP. NOTE: I Used something sharp and I don't think the battery will be the same. I punctured the battery itself, flames and sparks came shooting out.

It still worked but I no longer trust it. 2.Once open, position the battery on a flat surface as if going to place the battery in the PSP. (Flat side down, circuit board up as shown in Pic A) 3. Locate the black chip on the right next to the big chip. It's labeled with IC04. With the soldering iron, carefully melt the solder on the 1 SINGLE pin that is directly under the 4.

It's the last one on the left if facing it sideways. (As shown in Pic B) 4.Pull the pin UPWARD off the board. Leave the pin connected to the chip itself but bend it up so it isn't touching the board. Use the knife or something precise like a razor blade.

5.Close the battery up. If you wish, take some hot glue and seal it. If you opened the casing without having to break any plastic, then it should snap back on with no hassle. Creating the Jigkick 1. Connect the PSP via USB with the 256MB or higher memory stick in. Go into USB mode.

(You can use a memory stick reader if wanted) 2. Extract the 'Pandora' folder from the rar file to C:/ 3.Open cmd under Start->Run and type 'cd.' 2 times until you're in C:/>4.Type 'cd Pandora' and then 'cd mspformat'. 5.Type 'mspformat X'. Then type Y to confirm the format.